1994-95 Chrysler Town & Country

1994,95 Chrysler Town and Country stereo removal instructions to help you remove your radio fast!

Radio Removal:
1)Using a panel removal tool carefully pry up on the dash panel at the base of the windshield (speaker grille panel) to release the fastening clips securing it to the dash and pull out on the panel to remove.
2)Pry up the piece of trim that looks like a vent in front of the instrument light cluster on top of the dash using a panel removal tool to release and remove the trim.
3)Carefully pry out on the trim panel surrounding the heater controls using a panel removal tool to release the fastening clips securing the trim to the dash and remove the trim.
4)Extract the (3) screws securing the bottom of the radio trim bezel to the dash.
5)Extract the (3) screws securing the front of the instrument light cluster to the top of the dash
6)Extract the screw securing the back of the instrument light cluster to the dash, pry up on the light cluster with a panel removal tool, unplug all connectors and remove.
7)Extract the (3) screws securing the top of the radio trim bezel to the dash on the driver's side of the dash.
8)Pull the radio trim bezel away from the dash, unplug all connectors, shift the gear select lever into low, tilt the steering wheel down and remove the bezel
9)Extract the (2) screws securing the radio to the dash, pull the radio from the cavity, disconnect the ground strap unplug all connectors and remove the radio.


Did these instructions help?



It got the job done.$1.00

It really helped me out!$3.00
The 2 main things you will need when installing your new stereo is a wiring adapter and a dash kit.

Wiring Adapter



The wiring adapter is a piece which has a plug on one end and wiring sticking out of the other end. The plug connects to the factory wiring, and the wires are connected to the matching color wiring on the new stereo. This allows for connecting a new stereo without having to cut the factory wires.

Dash Kit

car stereo wiring adapter


Stock stereos have varying sizes, and if you just place an aftermarket stereo in the hole left by a stock stereo then there will be gaps around the stereo. The dash kit is a plastic piece which fits into the hole left by the stock stereo and fills in the gaps between the aftermarket stereo and the dash.