1989-91 Chevrolet Suburban

1989,90,91 Chevrolet Suburban stereo removal instructions to help you remove your radio fast!

Radio Removal:
1)Remove the (8) screws securing the instrument / radio trim panel.
2)Extract the (4) screws from the steering column bottom trim piece, (2) on each side of the column.
3)Place the gear selector in low (one) gear to provide additional clearance, then remove the instrument radio trim panel from the dash.
4)Extract the (2) bolts securing the fact of the radio; then, from below the dash, remove the rear support bolt from the bottom of the dash sheet metal.
5)Pull the radio out of the dash cavity, disconnect the radio harnesses and antenna, then remove the radio.

Did these instructions help?

It got the job done.$1.00

It really helped me out!$3.00
The 2 main things you will need when installing your new stereo is a wiring adapter and a dash kit.

Wiring Adapter

The wiring adapter is a piece which has a plug on one end and wiring sticking out of the other end. The plug connects to the factory wiring, and the wires are connected to the matching color wiring on the new stereo. This allows for connecting a new stereo without having to cut the factory wires.

Dash Kit

car stereo wiring adapter

Stock stereos have varying sizes, and if you just place an aftermarket stereo in the hole left by a stock stereo then there will be gaps around the stereo. The dash kit is a plastic piece which fits into the hole left by the stock stereo and fills in the gaps between the aftermarket stereo and the dash.