1982-92 Chevrolet Camaro

1982,83,84,85,86,87,88,89,90,91,92 Chevrolet Camaro stereo removal instructions to help you remove your radio fast!

Radio Removal:
1)Remove the (4) screws from the radio trim panel
2)Pull the panel up and outward towards the right.
3)Remove the (4) screws from the radio bracket, pull the radio out of the cavity.  Disconnect the antenna, speaker and all the electrical connections, then remove the radio.
NOTE: during the installation procedure the right side of the console must be pushed out 1/2 inch to accommodate some units.  Loosen the right side of, or remove the factory rear support bar.



Did these instructions help?



It got the job done.$1.00

It really helped me out!$3.00
The 2 main things you will need when installing your new stereo is a wiring adapter and a dash kit.

Wiring Adapter



The wiring adapter is a piece which has a plug on one end and wiring sticking out of the other end. The plug connects to the factory wiring, and the wires are connected to the matching color wiring on the new stereo. This allows for connecting a new stereo without having to cut the factory wires.

Dash Kit

car stereo wiring adapter


Stock stereos have varying sizes, and if you just place an aftermarket stereo in the hole left by a stock stereo then there will be gaps around the stereo. The dash kit is a plastic piece which fits into the hole left by the stock stereo and fills in the gaps between the aftermarket stereo and the dash.